diff --git a/README.md b/README.md
index 61b0dc0..c6a3394 100644
--- a/README.md
+++ b/README.md
@@ -974,6 +974,31 @@ mtproxymax tune clear all                  # Revert all
 
 Whitelisted params are regex-validated on input. Invalid values are rejected. Also available in **TUI: Settings > [n] Engine tuning**.
 
+#### Middle-End NAT address with policy routing
+
+If Telegram traffic leaves through a VPN gateway while ordinary IP discovery uses
+the server's WAN, ME key derivation may use the wrong public address. Persist the
+actual IPv4 egress address and disable probing through the existing tuning commands:
+
+```bash
+mtproxymax tune set middle_proxy_nat_ip 203.0.113.10
+mtproxymax tune set middle_proxy_nat_probe false
+```
+
+Replace the example with the public IPv4 address seen by Telegram. These overrides
+are saved in `/opt/mtproxymax/tunings.conf` and reapplied when primary or additional
+instance configs are generated. Each command can restart the running proxy. NAT
+must also preserve the source TCP port for a direct ME connection; an IP override
+alone cannot repair port translation or an unreachable route. With a compatible
+SOCKS upstream, a valid public `BND.ADDR/BND.PORT` tuple supplies the ME endpoint.
+
+Restore automatic engine behavior with:
+
+```bash
+mtproxymax tune clear middle_proxy_nat_ip
+mtproxymax tune clear middle_proxy_nat_probe
+```
+
 ---
 
 ### ✅ Verify & Audit
diff --git a/mtproxymax.sh b/mtproxymax.sh
index 8b28912..c09e6ca 100644
--- a/mtproxymax.sh
+++ b/mtproxymax.sh
@@ -4741,6 +4741,8 @@ _TUNE_WHITELIST=(
     "accept_permit_timeout_ms:server:^[0-9]+$"
     "prefer_ipv6:general:^(true|false)$"
     "fast_mode:general:^(true|false)$"
+    "middle_proxy_nat_ip:general:^((25[0-5]|2[0-4][0-9]|1[0-9]{2}|[1-9]?[0-9])[.]){3}(25[0-5]|2[0-4][0-9]|1[0-9]{2}|[1-9]?[0-9])$"
+    "middle_proxy_nat_probe:general:^(true|false)$"
     "log_level:general:^(debug|verbose|normal|silent)$"
     "direct_relay_buffer_budget_max_bytes:general:^[0-9]+$"
     "conntrack_control:server:^(true|false)$"
diff --git a/tests/test_me_nat_tuning.sh b/tests/test_me_nat_tuning.sh
new file mode 100644
index 0000000..f540b9f
--- /dev/null
+++ b/tests/test_me_nat_tuning.sh
@@ -0,0 +1,52 @@
+#!/bin/bash
+# Persistent ME NAT overrides must survive primary and instance regeneration.
+set -eo pipefail
+test_root=$(mktemp -d)
+trap 'rm -rf "$test_root"' EXIT
+export INSTALL_DIR="$test_root/install"
+export CONFIG_DIR="$INSTALL_DIR/mtproxy"
+export SETTINGS_FILE="$INSTALL_DIR/settings.conf"
+export _TUNE_FILE="$INSTALL_DIR/tunings.conf"
+mkdir -p "$CONFIG_DIR"
+MTPROXYMAX_SOURCE_ONLY=true source "$(dirname "${BASH_SOURCE[0]}")/../mtproxymax.sh"
+set -eo pipefail
+check_root() { :; }
+confirm_settings_restart() { return 0; }
+is_proxy_running() { return 1; }
+log_success() { :; }
+log_error() { :; }
+
+generate_telemt_config
+! grep -q '^middle_proxy_nat_' "$CONFIG_DIR/config.toml"
+
+tune_set middle_proxy_nat_ip 203.0.113.10
+tune_set middle_proxy_nat_probe false
+cp "$_TUNE_FILE" "$test_root/before"
+for invalid in 256.1.1.1 1.2.3 01.2.3.4 hostname '1.2.3.4"' '1.2.3.4/24'; do
+    if tune_set middle_proxy_nat_ip "$invalid"; then
+        echo "FAIL: accepted invalid NAT IP: $invalid" >&2
+        exit 1
+    fi
+done
+if tune_set middle_proxy_nat_probe yes; then
+    echo 'FAIL: accepted invalid probe boolean' >&2
+    exit 1
+fi
+cmp "$test_root/before" "$_TUNE_FILE"
+
+# Read persisted values during config generation, including an instance destination.
+for destination in "$CONFIG_DIR/config.toml" "$CONFIG_DIR/instance.toml" "$CONFIG_DIR/config.toml"; do
+    generate_telemt_config "$destination"
+    test "$(grep -c '^middle_proxy_nat_ip = "203.0.113.10"$' "$destination")" -eq 1
+    test "$(grep -c '^middle_proxy_nat_probe = false$' "$destination")" -eq 1
+    awk '
+        /^\[/ {section=$0}
+        /^middle_proxy_nat_/ && section != "[general]" {exit 1}
+    ' "$destination"
+done
+
+tune_clear middle_proxy_nat_ip
+tune_clear middle_proxy_nat_probe
+generate_telemt_config
+! grep -q '^middle_proxy_nat_' "$CONFIG_DIR/config.toml"
+echo 'PASS: ME NAT persistence, primary/instance regeneration, validation and clearing'