I built in calibrated the module and was having pretty good luck with it. It did not hold patterns very well when I turned it clockwise. After about an hour of use it stopped cycling through patterns. Now when I turn it on most of the top lights light up but nothing happens. I have disassembled it to verify that all ICs were installed in the correct order and to look for any bad welds. I do not see any. Now it just sits there with the lights on. Sometimes the lights don't even come on when I turn it off and turn it on again. They light back up if I do one more restart.
I built in calibrated the module and was having pretty good luck with it. It did not hold patterns very well when I turned it clockwise. After about an hour of use it stopped cycling through patterns. Now when I turn it on most of the top lights light up but nothing happens. I have disassembled it to verify that all ICs were installed in the correct order and to look for any bad welds. I do not see any. Now it just sits there with the lights on. Sometimes the lights don't even come on when I turn it off and turn it on again. They light back up if I do one more restart.